Manuels Connexes pour Mooreco 8201 Serie
Sommaire des Matières pour Mooreco 8201 Serie
- Page 1 DOC Glass Room Divider Part Numbers: 8201X-XXXX, 8221X-XXXX ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE ENSEMBLAJE INSTRUCTIONS DE MONTAGE DO NOT THROW AWAY! NO LA TIRE NE PAS JETER UPDATED AS OF: 03/30/2020 1 of 7...
- Page 2 Parts List Hardware P1 - Panel A - Screw M5 x 8mm A1 - Screw M5 x 50mm P2 - Crossbrace A2 - Screw M6 x 55mm B - Bumper P3 - Post C - Locking Caster P4 - Leg Base D - Mounting Bracket E - Screw Block G - Large Allen Wrench...
- Page 3 WARNINGS AND DISCLAIMERS ADVERTENCIAS Y RENUNCIAS AVERTISSEMENTS Review full assembly instructions and Previo a comenzar el proceso de Avant de commencer l’ assamblage check that all parts are present before ensamblaje favor revisar veuillez consulter instructions beginning assembly. Heavy or large instrucciones y asegurarse que cuenta con complètes et vérifier si vous avez toutes furniture may require multiple persons in...
- Page 4 STEP 1 Insert two Screw Blocks into slot of side extrusion on both sides of panel. To do this, tilt Screw Blocks at a 45 degree angle and drop into place. STEP 2 Attach two Mounting Brackets on both sides of panel. Secure to Screw Blocks with single allen screw inserted through center hole.
- Page 5 STEP 3 Install upright Post by inserting allen screws into Mounting Brackets and tightening into Screw Blocks (pictured in Step 1). Repeat for second Post. STEP 4 Insert Bumpers in Crossbrace. UPDATED AS OF: 03/30/2020 5 of 7...
- Page 6 STEP 5 Slide in Crossbrace between Posts. Secure to Posts with allen screws. Repeat on both sides of Crossbrace. STEP 6 Install Leg Base to bottom of Post and secure with allen screws as shown. Repeat for second Leg Base. UPDATED AS OF: 03/30/2020 6 of 7...
- Page 7 STEP 7 Push in Casters to feet of Leg Base. Repeat for second Leg Base. THIS COMPLETES ASSEMBLY INSTRUCTION UPDATED AS OF: 03/30/2020 7 of 7...