Germania KS 405 EC Traduction Du Mode D'emploi D'origine page 36

ENGLISH
32
Defects searching
Failures
The saw does not work
Not sufficient output
Missing chain lubrication
Chain Brake
Follow-up brake
Tracing
Electric engine is not
running
Low dilatability
Chain is not lubricated
Chain does not stop
quickly
Saw chain runs out
Causes
No power supply.
Broken cable
Chain brake activated
Activated power breaker
Worn-down carbon
brushes
Empty oil tank, Dirty
guiding oil groove
Worn-down brake belt
Worn-down carbon
brushes
Abhilfe
Insert the mains plug or
check the supply line.
Have the cable replaced
by a specialist workshop
or Güde Service.
Release chain brake (see
chapter „Operation" )
Check the supply line, visit
a specialist workshop.
Have carbon brushes
replaced by a specialist
workshop.
Fill up the oil tank. Clean
the oil guide groove on
the chain sword.
Visit a specialist workshop
immediately.
Have carbon brushes
replaced by a specialist
workshop.