Atlantic SOL Lighting SOLCC2 Manuel D'utilisation page 3

• Always verify that the lens cover is tightly secured before submersing the fixture.
• Never cut or shorten the light cord between the Control Module and the light
fixture. Altering the Light Cord will damage the LEDs and void warranty.
• 6-wire extension cords (part # SOLCCEXT) are available to add an additional
20' of cord to any SOL Color Changing Light. Only one cord can be used on
each light. Never connect multiple extension cords together.
SOLCCMX3 Control Module Installation
• The Control Module is weather-resistant with an IP54 rating. Do not submerse
it or expose it to heavy rainfall. It must be mounted off the ground close to the
power source. Failure to do so will void the warranty.
• Remove the red protective cap from the top of the control module and install
the antenna. Thread the black antenna on until snug, making sure it seals
against the gasket.
• Install the control box in a well-ventilated area to ensure that the module
operates within its specified working temperature.
• Verify that the control module input voltage is 12 volt AC. We recommend that
you use the transformer provided with this unit.
• Ensure that all cable connections are secure.
• Do not connect the power before the cord connections are finished.
• Do not cut or alter the cord between the SOL Light and the Control Module.
• The remote control requires two (2) AAA batteries (not included). Do not
touch the face of the remote while inserting batteries.
Connecting the Lights
Follow the connecting chart below to connect all cables. The SOLCCMX3 Control
Module and 3-way splitter will accept any combination of Color Changing SOL Light
styles. If more lights are required, multiple splitters can be connected together to
create more outlet connections.
Transformer
A larger transformer (80 watts maximum) is
required if additional lights are installed.
Do not exceed 80 watts per control unit.
Control Module
3-way
Splitter
SOLCC6
SOLCCLR
SOLCC2
3