Publicité
Les langues disponibles
Les langues disponibles
TESTING
❒ Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
riod before it will detect motion. When
first turned on wait 1
❒ Set SENSITIVITY to mid position and
ON-TIME to TEST position.
TEST 1 5 10 MIN
ON-TIME
Avoid aiming the control at:
• Pools of water or objects that change
temperature rapidly, such as heating vents
and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects
reflecting daylight may trigger the shut-off
feature. Do not point other lights at the
sensor.
6 ft.
(1.8 m)
Maximum Range
/
minute warm up pe-
1
2
/
minutes.
1
2
LO - M - HI
SENSITIVITY
30 ft.
(9.1m)
Maximum
Coverage Angle
The detector is less sensitive to motion di-
rectly towards it and more sensitive to across
motion.
Motion
Least Sensitive
❒ Walk through the coverage area noting
where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area.
Note: Grasp the sensor
only as shown and turn
the entire sensor. Any
other method may
damage the sensor.
Do not force it past
the stops.
150°
❒ Set the SENSITIVITY as needed. Too much
sensitivity may increase false triggering.
❒ Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
6
Motion
Sensor
Most Sensitive
240°
Sensor Aiming
Adjustment Angle
598-1165-05
Publicité
