PROakcess BLACK ICE Mode D'emploi page 5

English
The BLACK ICE electric coolers can be used wherever you need a snack or a cold drink: camping, boating,
parties, barbecues, hiking, etc.
+/- 16°C is the temperature difference your cooler can reach compared with outside temperature.
Working by temperature exchange, it allows the option to heat and keep warm food.
50° is reached in 30 minutes. You can use it all year round!
Very practical, it can be connected to 220V AC for domestic use, or to the 12V DC cigarette lighter socket in
a car or on a boat.
1- 1-WARNINGS WARNINGS
- Before use, check that the cables, plugs and casings are not damaged. DO NOT use if
damaged or worn parts.
- NEVER fill the unit with water or ice.
- DO NOT immerse the unit in water.
- DO NOT put ice packs inside.
- DO NOT use under the rain.
- DO NOT handle if your hands are wet.
- Use in a dry and ventilated area.
- DO NOT obstruct the air flow to the unit. Ventilation slots must be kept clear to allow the unit to operate
properly and to avoid dangerous overheating.
- DO NOT place the appliance in direct sunlight or in an enclosed area where ventilation is restricted or
where there are other sources of heat.
- As with all electrical equipment, keep away from children and pets.
- Use only with a 12V DC (negative ground) or 220V AC power supply.
- Unwind the required power cable completely before use. DO NOT use this cable while it is coiled, as this
may cause the cable to overheat.
- This item is not intended for the storage of medicines, chemicals, or anything that is not food or drink.
- This cooler is intended for temporary use. It is not a refrigerator designed for permanent installation or for
professional use.
- When plugged in or after connection, keep the lid closed as much as possible.
- DO NOT pull out the plugs by pulling on the cables.
2- USE AND OPERATION 2- USE AND OPERATION
1) Cooler function:
- Load your cooler with already cold food/drinks if possible, to avoid high consumption and the cooler ha-
ving to run at full capacity.
- Select the cold mode.
- Choose the 220V or 12V connection mode.
- Select MAX mode to cool faster, or ECO mode to lower the temperature more slowly or maintain it.
- The LED on the product is displayed in GREEN.
2) Heat function :
- Load your cooler, if possible, with food that is already hot to avoid high consumption and the engine ha-
ving to run at full speed.
- Choose the warm mode.
- Choose 220V or 12V mode.
- Select MAX or ECO mode depending on the desired intensity.
- The LED on the product is displayed in RED.