Elta PP-4209 Mode D'emploi page 21

The temperature regulator
The temperature regulator is a highly sensitive part. Due to this the
and should not fall down.
Note: Only the supplied temperature regulator has to be used. Never
use a different temperature regulator !
When plugging-in the temperature regulator make sure that it is plugged-in
correctly.For removal don't pull at the cable but at the plug of the
temperature regulator itself.Never use force and do not bend.
Keep clean the temperature regulator and the pins of the socket.
If the automatic temperature sensor is damaged, switch-off immediately
dealer.
Before insert or removal of the automatic temperature regulator make
sure that the scale of the automatic temperature regulator is set to OFF.
Otherwise a breakdown or over-heating may happen.
Technical data
220-240V~ 50-60Hz 1500W
Waste Management
The symbol above and on the product means that the product
is classed as Electrical or Electronic equipmentand should not
be disposed with other household or commercial waste at the
end of its useful life. The Waste of Electrical and Electronic
Equipment (WEEE) Directive(2012/19/EU) has been put in
place to recycle products using best available recovery and recycling
techniques tominimise the impact on the environment, treat anyhazardous
substances and avoid the increasing landfill. Contact local authorities for
information on the correct disposal of Electrical or Electronic equipment.