Publicité
Les langues disponibles
Les langues disponibles
HARDWARE CONTENTS
AA
Washer
Qty. 2
To prevent the unit from tipping over, secure it to a
wall in the following manner: Drill a hole in the wall
using a 1/4 in. drill bit (not included). Insert the
plastic anchor (BB) into the hole. Insert the screw
(CC) through the washer (AA) then through the back
of the top shelf wire and into the plastic anchor (BB)
as shown. Be sure unit is secure and doesn't
wobble or tip over.
!
Unit must be placed on a level surface or
leveled with included hardware (when
applicable).
Do not sit or stand on or allow children to
climb, sit or stand on the assembled
product.
For safety reasons, it is imperative that this
unit be mounted on the wall or floor.
Unit can tip over causing severe injury or
death.
Do not exceed the recommended weight
limits.
Evenly distribute the weight on each level
and always keep the heavier loads on the
bottom.
Before cutting, drilling or hammering into
any wall or floor surface, verify the location
of electrical, plumbing and gas lines.
Cutting may cause serious injury.
WARNING
BB
Plastic Anchor
Qty. 2
CC
Screw
Qty. 2
AA
CC
BB
Publicité
