Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION OF 37MT, 41MT AND 42MT FIELD TERMINAL OUTER INSULATOR
WARNING!!!!ALWAYS USE PROPER EYE PROTECTION WHEN PERFORMING ANY MECHANICAL REPAIRS TO A VEHICLE –
INCLUDING, BUT NOT LIMITED TO, ANY INSTALLATION AND OR REPAIRS TO THE DELCO REMY
USE PROPER EYE PROTECTION CAN LEAD TO SERIOUS AND PERMANENT EYE DAMAGE.
DANGER!!!
Only perform the mechanical functions that you are properly qualified to perform. Mechanical repairs that are beyond your
technical capabilities should be handled by a professional installation specialist.
FOLLOW ENGINE AND/OR VEHICLE MANUFACTURER'S INSTRUCTIONS CAREFULLY WHEN REMOVING AND INSTALLING THE
STARTER.
•
The Grommet and Insulator-Terminal were designed to replace the insulator-Terminal (rubber grommet).
•
The Insulator-Terminal inside the frame has been included in this package in case it needs to be replaced.
ASSEMBLY INSTRUCTIONS
•
Insert Grommet over field coil terminal inside of frame hole.
•
Place Insulator-Terminal on top of seal. Make sure that the flat portion is facing the commutator end of starter (opposite of the
drive end) and curved face conforms to the starter frame.
•
Place connector strap on the motor terminal of the solenoid first, then place other end on top of the outer insulator. Insert torx
head screw through strap and outer insulator and torque to 75-95 lb in.
•
The torx head screw that fastens the solenoid to the connector strap on the 37MT or 41MT should be torqued to 75-95 lb in.
The nut fastening the connector strap to the solenoid on the 42MT should be torqued to 180-240 lb in.
Grommet
Insulator – Terminal
Field
Terminal
Stud
Technical support: USA 800 372 0222, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 3183 0384 or visit
delcoremy.com.
NOTICE
- Only licensed Delco Remy products and component parts should be used, and the use of other parts or modifications not approved by PHINIA
will void all applicable warranties. The failure to carefully follow these Instructions, set forth herein, will void all applicable warranties. DELCO REMY is a
registered trademark of General Motors LLC, licensed to PHINIA Technologies Inc.
© 2023 PHINIA Inc. All rights reserved
Insulator – Terminal
Commutator End of Motor
1
Instruction Sheet
10504017
08FE24 C0008709 REV9
®
PRODUCTS. FAILURE TO
Motor
Frame
Publicité
Manuels Connexes pour Delco Remy 37MT
Sommaire des Matières pour Delco Remy 37MT
- Page 1 • The torx head screw that fastens the solenoid to the connector strap on the 37MT or 41MT should be torqued to 75-95 lb in. The nut fastening the connector strap to the solenoid on the 42MT should be torqued to 180-240 lb in.
- Page 2 • El tornillo de cabeza torx que sujeta el solenoide a la correa del conector en el 37MT o 41MT debe apretarse a 75-95 lb pulg. La tuerca que sujeta la correa del conector al solenoide en el 42MT debe apretarse a 180-240 lb pulg.
- Page 3 • Le vis de tête torx qui pris le solénoïde à la ceinture du connecteur sur le 37MT ou 41MT doit être serré à 75-95 lb pouces. La noix qui sujet la ceinture du connecteur au solénoïde en le 42MT doit serrer à 180-240 lb pouces.