Installing And Removing The Battery Pack; Initial Setup; Basic Operation - DeWalt DCT410 Guide D'utilisation

The belt hook 24 can be be attached to either side of the
tool using only the screw 23
left- or right- handed users. If the hook is not desired at all, it
can be removed from the tool.
To move belt hook, remove the screw
belt hook in place then reassemble on the opposite side.
Fig. K
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. L)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 1
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
2
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. L
2
Proper Hand Position (Fig. M)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the handle
and one hand on the camera cable
provided, to accommodate
that holds the
23
24
23
into the tool handle, align the
1
9
.
5
Fig. M
5
Getting Started (Fig. A, D)
Turning the Unit On
1. Turn the screen on by pushing the screen power
button .
12
2. Turn the camera on by turning the camera cable on/off
switch .
8

Initial Setup

language setup
1. Press the forward 20 or back
English, French or Spanish.
2. Press the OK button 19 to confirm and exit.
Date and Time setup
1. Press the forward 20 or back
field to change.
2. Press the OK button to activate the field (field
19
turns green).
3. Press the forward or back arrow to change the
activated field.
4. Press the OK button to save changes (field turns yellow).
5. Repeat above steps to change remaining fields.
6. Press the main menu button

Basic Operation

nOTE: At any time during the camera operation, pressing
the main menu button 17 will return to the previous menu.
To Record Photos or Videos
Be sure a micro SD card (sold separately) is loaded in the
card slot 10 .
1. Turn both the camera 3
2. Aim camera at destination.
English
9
18 arrow to select
18 arrow to highlight the
17 to exit.
and the handle set 9 on.
9