Publicité
S x 1
T x 1
17
T
S
IMPORTANT NOTICE
OTTOMAN OPERATING INSTRUCTIONS
Once your bed frame is completely assembled, the slat unit will not operate correctly unless a mattress is placed on the slat frame. Position the
mattress on the slat frame whilst it is in the closed position.
PLEASE NOTE
- It takes a lot of force to make the initial movement of the ottoman. This is a design feature of the product so that it does not fall shut
- the nearer to being closed the ottoman is, the easier it is to move. When the ottoman is al most shut, it will close completely under its own weight.
When lowering the slat unit for the first time, take care to make sure it does not rub unevenly on the inside face of the side rails. If it does, the bed
has been assembled slightly out of square. This can be rectified by moving the foot end of the bed slightly to the left or right whilst leaving the head
end stationary.
PISTONS
The pistons used in the construction of this product are extremely strong and cannot be operated by hand when taken off the ottoman. All pistons
are tested for correct pressure and operation before being attached to the slat unit.
Initially it might appear that the pistons are very stiff when opening and closing the ottoman.
THIS IS PERFECTLY NORMAL
When fully assembled and the mattress is in position, please raise and lower the ottoman 4/5 times to ensure the gas piston
are fully lubricated.
14/14
Publicité
