Publicité
Les langues disponibles
Les langues disponibles
Pre-Installation (continued)
STAINLESS STEEL STRAW
Not all water bottles are created equal. Almost all 3 and 5 gallon (11 & 19 L) water bottles
are recycled and handled extensively during cleaning, lling, and shipping. As a result,
they are very prone to developing hairline fractures and pinhole leaks that are not always
obvious to the end user until the time of installation.
IMPORTANT: Never knowingly install a
defective water bottle on a water dispenser.
Return immediately for replacement.
To adjust the stainless-steel straw for the appropriate water bottle capacity,
install the locking clip on the corresponding indentation.
READY-TO-DISPENSE INDICATOR LIGHTS
Color
Behavior
Red
Flashing
Steady on
Off
Blue
Steady on
Off
Yellow
Flashing
Off
Operation
1
Dispensing cold water
Ensure the lower front panel is properly installed before
dispensing water.
Place a glass under the water spigot.
Press the cold water button (G).
Meaning
The heater is operational.
The hot water has reached optimum temperature and is ready for dispensing.
The hot water heating system is off. The water in the tank may still be very hot.
The cold water has reached optimum temperature and is ready for dispensing.
The cooling cycle is in progress. It is possible to dispense water during the cooling cycle;
however, optimum cooling temperature may not yet be achieved.
The water level inside the reservoir is low or the water bottle is empty.
All water levels are normal.
G
2
Dispensing room temperature
water
Place a glass under the water spigot.
Press the room temperature water button (F).
F
6
Publicité
