Table des Matières
Publicité
EN
This product is an OEM device, with possibility to be significantly altered
by user
through hardware enhancement/modifications and/or
configuration changes, even at run-time. Thus, it is up to the
manufacturer of the final equipment in which this device will be used to
ensure compliance with regulations and standards (including CE and
FCC marks) after having mounted and configured the device as it will be
delivered to the end-user.
This product should be handled like a CMOS semiconductor device. The
user must take all precautions to avoid build-up of static electricity
while working with this device. The connectors and/or device pins
should not be touched with bare hands.
This product (including all accessories and options) is not intended for
household use. After use the device cannot be disposed of as household
waste, and must be treated, recycled and disposed of in an
environmentally sound manner.
EU only: in accordance with the WEEE (Waste Electrical and
Electronic Equipment), SpringCard can take back end of life
devices. Visit tech.springcard.com/weee for details and
conditions.
Standard warranty: 2 years
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Information to user
Changes or modifications not expressly approved by Identiv could void the user's authority to operate the
equipment.
FR
Ce produit est un composant OEM, qui peut être significativement
modifié par l'utilisateur tant au niveau matériel que par configuration
logicielle, y compris dynamiquement. Il appartient donc au fabricant de
l'équipement final dans lequel ce composant sera utilisé de s'assurer du
respect des normes, standards et réglementations (y l'obtention des
marques CE et FCC) après avoir monté et configuré ce produit tel qu'il
sera livré à l'utilisateur final.
Ce produit doit être manipulé avec les mêmes précautions qu'un
composant semi-conducteur CMOS. Éviter l'accumulation d'électricité
statique. Ne pas toucher les connecteurs ou les broches de l'appareil à
main nue.
Ce produit (y compris tous ses accessoires ou options) n'est pas destiné
à un usage domestique. En fin de vie, il ne doit pas être éliminé avec les
déchets ménagers, mais doit être traité, recyclé et éliminé dans le
respect des normes environnementales.
UE: conformément à la directive WEEE (Waste Electrical and
Electronic Equipement), SpringCard peut reprendre les
produits en fin de vie. Les détails et conditions sont
disponibles sur tech.springcard.com/weee
Produit garanti 2 ans
PMI14049-AB
Publicité
Table des Matières
