Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Before Using Your Freezer
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
3 Storage Baskets
1 Ice Shovel
1 Instruction Manual
Before connecting the freezer to the power source, let it stand upright for approximately 4 hours.
This will reduce the possibility of a malfunction in the cooling system from improper handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page 9)
Installing Your Freezer
This appliance is designed to be free standing only and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
Allow 5 inches of space between the back and sides of the freezer, which allows the proper air
ventilation. Adjust the feet to keep the freezer level.
Your freezer should be conveniently located in a dry, well ventilated room away from direct sunlight
and sources of heat (stove, heater, radiator etc.) Direct sunlight may affect acrylic coating and heat
sources may increase electrical consumption. Do not install the freezer where the temperature will go
below 32 °F or above 100 °F. Temperatures outside of this range may affect the performance and
longevity of the unit
Avoid locating the freezer in moist areas.
Plug the freezer into dedicated, properly installed-grounded wall outlet. Do not, under any
circumstances, cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center. This unit is not designed to be installed in an RV or used with an
inverter.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool for 2~3
hours before placing food in the freezer compartment.
freezer
freezer
freezer
freezer
freezer
5
freezer
Publicité
