ECG EV 2510 Mode D'emploi page 6

Using both plates in the same time
Note: Both plates can be used in the same time, but you have to be careful that the dishes do not extend
outside of the plates.
1. Put food in the pot (the total amount of water and food in the pot should not exceed 80% of the volume of
the pot, to prevent overflowing). Cover the pot with a lid and place it on the hot plate.
2. Plug the hot plate in the outlet. The degree of heating can be controlled by turning the thermostat toward
the position MIN or MAX. Turn the thermostat control from the "MIN" position to maximum. The control
light comes on and the hot plate starts warming up.
3. There are two points, which you have to remember when using new hot plate:
• When using the new hot plate the first time, the surface can emit odor or smoke. This is normal and it
is caused by an invisible layer of protective film applied to the appliance during production.
• Before the food starts to boil, the control light on the hot plate can go off temporarily because the
thermostat temporarily switches off. This safety feature is a normal function of the hot plate.
When you finish cooking put the control in the MIN position and always disconnect from power
4.
supply. Wait until the appliance cools off before moving it or cleaning it.
CLEANING AND MAINTENANCE
1. Make sure that the power cable is unplugged. Clean the hot plate using gentle detergent or gel cleaner
and soft cloth after it thoroughly cools down.
DO NOT CLEAN THE APPLIANCE WHILE IT IS HOT.
2. DO NOT USE hard brushes, abrasives or alcohol, kerosene or other organic cleaners.
3. Do not immerse the hot plate in water while cleaning it.
4. Store the hot plate in a cool place after cleaning.
TECHNICAL SPECIFICATIONS
Two plates with diameter 185 (1500 W) and 155 (1000 W) mm
Nominal voltage: 220–240 V~ 50–60 Hz
Nominal input power: 2500 W
NOTE: The following situations void the warranty:
Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device,
the use of force, alterations or repairs made by a party other than authorized service center.
Components subject to normal wear and tear are not covered under warranty.
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into plastic
recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specified location for recycling electric and electronic equipment. Prevent negative
impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.
6
08/05