EAL EUFAB 16257 Manuel De L'opérateur page 14

Camera settings (symbol shows a screwdriver in the top left of the display):
Stop mode:
Date/Time:
Automatic switch off:
Screensaver:
Beep:
Language settings:
TV mode:
Light frequency:
Full light:
Format:
The standard settings:
Version:
Mode button (Position 14 in the overview)
Pressing the Mode button multiple times allows you to switch the function modes in the following sequence:
Video mode – Photo mode – Play mode.
Parking mode button (Position 12 in the overview)
Press the Parking mode button before switching the camera off. The „P symbol" will be shown in the top right
of the display. After the camera is switched off, it is in Parking mode, see also the „Gravity sensor" in section
6.5 Functions.
14
If the stop mode is activated, the video recording is saved automatically in the
event of an impact (this recording is not deleted automatically). Three levels may
be set for the severity of the impact.
Switch off – 2G (light impact) – 4G – 8G (serious impact)
Set the date and time using the cursor buttons and confirm each entry by
pressing the OK button. Press the menu button to exit this menu item.
Set whether and when the camera is to switch itself off automatically when in
Standby mode.
Set whether and when the screensaver is to be activated.
Switch the button sounds on/off
Switch off – open (switched on)
Set the menu language and confirm the selected language using the OK
button.
Set the television standard that matches your television.
NTSC – PAL
Set the frequency of the power network of your country.
50 Hz – 60 Hz
You can switch the Power-LED on permanently.
Switch off – open (switched on)
The memory card is formatted, all data is lost.
Cancel – Confirm
The factory settings of the camera are restored.
Cancel – Confirm
Shows the version of the software on the camera.