Osram OPTOTRONIC OT 20/220-240/24 Guide Rapide

OPTOTRONIC
OT 20/220-240/24
picture only for reference, valid print on product 5)
Operating voltage and power consumption of LED-Modules have to correspond with the OT's rated values.
Power supplies can be connected in parallel on the primary side but not on the secondary side.
Wiring limitations of OPTOTRONIC
Supplies with common "-" or "+" wiring is forbidden by the EN 61347-2-13 norm "Safety for LED controlgear".
The same limitation must be
observed when using external
12)
dimming devices.
Environment protection: Maximum permissible ambient temperature (50°C) must not be exceeded. Make sure there
is adequate space to avoid a build-up of heat. In critical installations the temperature at t c must be controlled.
The luminaire manufacturer is responsible for providing the required clearance and creepage distances and also for
the protection against electrical shock, especially for the line and load wires.
Additional informations are available at www.inventronicsglobal.com
> Downloads electronic power supplies for LED-modules
> Technical guide OPTOTRONIC
LED Power Supply
®
1)
2)
3)
4)
devices in system installations: The installation of OPTOTRONIC
®
15)
®
6)
Output
8)
7)
Input
≤ 10m
14)
9)
10)
Power
®
11)
13)