Publicité
Les langues disponibles
Les langues disponibles
1
Drill this
face
1
4
7mm
Screw Base
Sanindusa S.A. reserva o direito de fazer alterações técnicas sem aviso prévio.
Sanindusa S.A. reserva el derecho de hacer alteraciones técnicas sin previo aviso.
Step 1 - Pre-Installation Checks
1.
Check the tray is level on all sides (the bubble on the spirit level must be in the centre of the 2 lines).
2.
Stand in the tray and check that there is no adverse movement (correct if necessary).
3.
The walls should be tiled and grouted up to the tray.
4.
The tiles and the tray should be sealed using a good quality bathroom sealant.
•
Spray the seal and joints with the shower head and check for leaks when the silicon has cured.
•
Check the plumbing for leaks.
•
DO NOT plasterboard over the tray.
•
DO NOT grout the tiles when the enclosure has been fitted, the grout
may discolour the aluminium profiles.
•
Make sure the tray is installed as per the manufacturer's instructions.
•
When all of the above has been completed please proceed to the Step 2.
Step 2 - Wall Profile Positioning
1.
On both wall profiles drill three 4.5mm holes through the lip. Place them 7mm in from the edge and
approximately 100mm from each end and the other positioned in the centre.
•
Drill the holes from the back (through the face that goes to the wall) - deburr all holes.
2.
Place both Wall Profiles 10mm in from the outside of the tray. Make sure that both Wall Profiles are
completely vertical using a spirit level and mark the wall through the holes with a pencil.
3.
Drill the wall with a 6mm Masonry Drill Bit (not supplied) where the Wall Profiles are to be positioned. Fit
the Wall Plugs supplied (if going in to a brick or block wall). If going into a plasterboard wall you will need to
purchase appropriate wall fixings. Wipe clear all debris from the Tray before referring to the next stage.
4.
Take one Wall Profile and position it on the Tray, place a bead of Bathroom Sealant (not supplied) the width
of the Wall Profile between the tiled wall and tray. Fit Screw Bases to the 40mm screws (supplied) and secure
the Wall Profile to the wall. Do not over tighten the screws into the Wall Profile as this will misshape the Wall
Profile. Ensure the Wall Profile stays completely vertical throughout this procedure using a Spirit Level.
•
NOTE: Only one Wall Profile is fitted at this time, the other Wall Profile is fitted later.
•
NO sealant should be present between the Wall Profiles and the tiled walls vertically prior to screw
fixing.
5.
Seal the gap between the Tray and Wall Profile with a Bathroom Sealant (not supplied).
•
Failure to carry out Stages 4 & 5 can result in serious water damage and is not covered by the
Guarantee.
2
10mm
Sanindusa S.A. reserves the right to introduce technical improvements without previous notice.
2
Width
of the
Wall
Profile
4
Sanindusa S.A. si reserva il diritto di effettuarre cambiamenti tecnici sensa preaviso.
5
3
Sanindusa S.A. réserve le droit de faire des altérations techniques sans information prealable.
1
2
Publicité
