Publicité
Les langues disponibles
Les langues disponibles
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
Units with protection class IP65 are dust-tight and completely protected against contact (first code number). They are also protected against splash water
from any angle (second code digit). That is why this unit can also be used out‐ doors. Events units are generally only designed for temporary use however
(event lighting) and not for permanent use outdoors. The specified protection class does not make a statement about the weather resistance of the units
(resistance to changing ambient conditions as well as against the effects of sunlight and UV rays). The seals and screw connections of the units must be
checked regularly to ensure a fault-free operation.
This unit is virtually maintenance-free, but you should check the unit regularly for mechanical and electrical aspects.
Assess the operating environment and establish an inspection and cleaning schedule that follows the guidelines below:
•
Disconnect the unit from the power supply and allow it to cool completely before inspecting and cleaning.
Check that the screws and bolts used to install the unit are securely tightened and free from corrosion.
•
Check the housing, fixing points and installation points, they must not show any signs of deformation, wear or fatigue.
•
•
Check the mechanically moving parts, these must not show any signs of wear or fatigue.
•
Check the electrical power and signal cables, they must not show any damage or fatigue.
•
Do not use solvents, abrasives or other aggressive products to clean the unit.
•
Wipe the unit and clean the glass plate with a soft, clean, lint-free cloth moistened with a weak cleaning solution. Place the solution on the cloth
and not on the surface to be cleaned. Avoid rubbing glass surfaces.
Dry the unit, connectors and contacts with a soft, clean, lint-free cloth or low-pressure compressed air before re-powering the unit.
•
Publicité
