Nordcap HSW 001 E Manuel D'installation Et Emploi page 20

INSTALLATION INSTRUCTIONS
INSTRUCTIONS FOR POSITIONING
•
To position counter top appliances it is advisable to ensure for the weight of the appliance.
•
Keep 10 cm of gap all around the appliance.
•
If the walls next to the appliance are of inflammable material, they should be suitably clad.
•
Fire prevention regulations must be scrupulously observed.
•
The electric wiring must never be under strain. Do not obstruct the suction inlets or heat dispersion outlets.
•
Remove the protective film.
•
Place the machine on a stable and steady surface (rear wall, support base etc...) using the fixing bracket provided. Fix the
bracket on the 2 holes of the rear panel of the machine (see picture below).
To make this operation easier and considering the space available, the bracket can be cut or folded according to the
desired length along the traced points.
The fixing screw on the opposite side of the machine is not provided by the manufacturer.
OPPOSITE HINGE DOOR
1. Remove the screws on the bottom hinge (B) and hold the door
firmly
2. Unscrew and remove the pivot placed on the left side of the
panel frame (A)
3. Remove the black security tap on the right side (C) and fix it
on the free hole you can find on the left side (A).
4. Screw the pivot on the right side of the panel frame (C)
5. Place the door fixing it on the pivot on the right side (C)
6. Screw the bottom hinge on the right side (D) and fasten the
door.
19
GB
Ed. 0722