Publicité
FOR MODELS HF75K ONLY
1. Align the holes in the upper housing with the two mounting holes on the handle
as shown.
2. Secure handle through holes provided.
FOR MODELS WITH WHEELS
These models come complete with
wheels and handles. The wheels, the
handles, and the mounting hardware
are all located in the shipping carton.
1. Loosely secure the Axle Bracket
to the Wheel Support Frame.
2. Slide the axle through the Axle
Bracket.
3. Install the wheels on the axle,
with the valve facing outward.
4. Place the flat washers and
fastening nut on each axle end.
5. Tighten the Axle Brackets.
6. Position the Height Adjustment
Pipe to align the hole as shown.
7. Insert and tighten the bolt (M8).
GUARD ASSEMBLY (FOR CANADA ONLY)
TO ATTACH THE GUARD
1. Remove the screws from the upper shell and set aside.
2. Align the holes in the Guard with the holes in the upper shell as
shown.
3. Secure the guard to the upper shell by inserting and tightening the
screws.
TO ATTACH THE INTERCEPTOR
1. Remove the screws from the lower shell and set aside.
2. Align the holes in the Interceptor with the holes in the lower shell
as shown.
3. Secure the Interceptor to the lower shell by inserting and tightening
the screws.
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
Handle
Wheel
Support
Frame
Wheel
Models HF125K / HF175K / HF215K
-6-
Handle
Handle Installation HF75K
Thermostat
Knob
Axle
Guard
Interception
Guard
Interception
Screw
Air
Inlet
Fuel
Tank
Flange
Publicité
