YABER E1 Manuel D'utilisation page 6

Note:
1).Install 2 pieces of AAA batteries into the remote before using it. Do not
combine new batteries with old ones in remote controller, which can cause
operation failure due to insufficient power supply.
2).When using the remote controller, please make sure that the signal
transmitter of the remote controller aims at infrared signal receiver of the
projector.
3).If you are not using the remote controller for an extended period, please
take out batteries to prevent batteries leakage.
INSTALLATION
1. Installation Method
The projector can be placed on the stable desk to project the image like
following methods:
Projector
screen
1. Front Projection Table mount
2. Projection Distance and Size
Aspect Ratio: 16:9
Distance (ft.)
4.4
5.9
7.5
9.8
The recommended projection distance is about 5.9ft.
The image size depends on the distance between projector and screen, there may be
3% deviation among above listed data. Different settings cause various distances.
EN 8
screen
Projector
2. Rear Projection Table mount
Screen Size
45"
60"
80"
100"
STARTING PROJECTOR
Turn on the projector: Connect to the power cable, when the red indicator
light is on, press the power button on the panel ( Press the power key on the
remote control ) to start the projector, the indicator turns from the red to
blue, the projector is on.
Turn off the projector: When the projector is working normally, press the
power button, the indicator turns from the blue to red, the projector is in
shut down.
IMAGE ADJUSTMENT
1. Electric Focus Adjustment
Manual focus-
Place the projector lens perpendicularly to the projection screen or curtain
wall, and press the F+/F- key on the remote control or the projector panel,
until the image is clear, that means the image focusing is finished.
Note: If it is still blurry, please try to adjust the projection distance.
EN 9
Manual focus+