Home Decorators Collection 72058 Guide D'utilisation Et D'entretien page 7

Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To avoid possible electrical shock, turn the
electricity off at the main fuse box before wiring. If you
feel you do not have enough electrical wiring knowledge
or experience, contact a licensed electrician.
NOTE: For better fan performance, make sure the
mounting plate is level. Additional washers (FF)
(not included) may be needed to insert between the
outlet box and mounting plate.
□
Turn the power off.
□
Loosen the two mounting screws (GG) supplied with the
outlet box, but do not remove the screws.
□
Securely attach the mounting plate (A) to the outlet box by
sliding the mounting plate (A) over the two mounting screws
(GG) supplied with the outlet box. Pull the 120-volt supply
wires (the black, white and ground wires) out of the outlet
box (GG) and through the hole in the mounting plate (A) and
lay them to the side.
3
Connecting the safety cable
□
Turn the wood screw (LL) (not provided) into the ceiling.
□
Place the looped end of the safety cable (S) onto the wood
screw and then tighten the screw firmly, or connect the
safety cable directly to the outer joist.
2
Hanging the fan-motor assembly
□
Attach the trim ring (B) to the fan motor assembly (C)
from the opening of the motor housing. Make sure the
slots of trim ring (B) are on top.
□
Carefully lift the fan-motor assembly (C) and hang the fan
motor assembly (C) on the hook of the mounting plate (A)
by utilizing one of the holes at the outer rim of the motor
housing so that it is securely suspended. Then connect
the wiring to your fan according to step 4 "Making the
Electrical Connections".
LL
S
7
Please contact 1-800-986-3460 for further assistance.
S
Washer
Lock
washer
A
C
B
HOMEDEPOT.CA