Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS - VIPER WALL SIZES 1, 2, AND 3
STEP I - MOUNTING PREPARATION
POWER MUST BE OFF.
(WIRING MUST BE PERFORMED BY A QUALIFIED ELECTRICIAN)
•
Remove fixture mounting bracket (A) from fixture by loosening the hex set
screws (B).
•
Remove paper backing from gasket (C) and apply to mounting bracket (A)
on the side shown. (See FIG.1)
•
Align holes in bracket to your matching j-box holes.
•
Secure and level mounting bracket to the j-box.
•
If no junction box is available, mounting plate must be securely anchored to
wall with appropriate hardware (not provided).
•
Apply a bead of silicone caulk (not provided) around the top and two sides
of the bracket where it meets the wall.
STEP II WIRING
•
Connect service leads to fixture power leads according to local and National
Electric Codes. (See FIG.5)
•
For direct wire connections, connect ground wire to the green wire.
•
Connect black to line and white to neutral then push connections back
inside j-box (See FIG.2)
STEP III FIXTURE MOUNTING
•
Hold fixture (D) at slight angle as shown (FIG.4), align, lower, and rotate
over mounting bracket (A) until fixture sits flat against wall.
•
Tighten the two (2) set screws (B) securely to capture the mounting
bracket (A).
•
Check to ensure the fixture is securely mounted.
•
Energize product.
BATTERY BACK-UP (BBU) INFORMATION
•
FOR UNITS EQUIPPED WITH BBU:
•
Must be charged for 24 hours before use. *Once A/C power is supplied to
fixture, emergency BBU will remain active, even if A/C power is removed.
•
BBU units are only equipped for 120V or 277V input.
•
Maximum mounting height: 23.8 ft.
IMPORTANT SAFEGUARDS
•
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
•
Do not mount near gas or electric heaters.
•
Equipment should be mounted in locations and at heights where it will not
readily be subjected to tampering by unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
OUTSIDE
FIXTURE
COMMON
BUILDING
CONNECTION
95062889 Rev A
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
INSIDE
FIXTURE
LINE
BLK
WHT
GRN
GROUND
PUR
DIM +
PNK
DIM -
FIGURE 5
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
FIGURE 1
B
D
A
FIGURE 4
SHEET 2 OF 4
A
ONCE ALL CONNECTIONS ARE
MADE, PUSH ALL CONNECTORS
AND EXCESS WIRING INSIDE J-BOX
FIGURE 2
FIGURE 3
A
D
B
www.beaconproducts.com
C
Publicité
