Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Inserting Headphones
Get the headphones ready with the earebel lettering for the
1
right side and the e logo for the left side.
Only for models with a slot in the inner
fleece strip:
Insert the headphone with the ear cushion
pointing upwards through the slot in the
fleece. Slide it up to the round opening in
the hat; it is essential that you note the left
and right side here.
2
3
Guide the headphone out from the inside of
the hat/headband through the round open-
ing.
5
Check that the head-
phones fit correctly:
Repeat steps 1 to 4 with the second
6
The bulge should
headphone on the other side.
not be visible.
Now connect the earebel to your smart-
7
phone or player and enjoy perfect
sound!
(Similar to those shown.)
16
4
Press the bulge on the
edge of the opening
into the headphone.
Correct!
Wrong!
Headphone Structure
4
3
2
1
1 Micro-USB socket for charging
2 LED
3 Microphone for making phone calls
4 Soft-touch control pad
Connecting Headphones via Bluetooth
To connect the headphones to a smartphone
1
or other Bluetooth
Play/Pause button (on the soft-touch control
pad) for 5 seconds until the LED light starts to
flash alternately
Hold down
can now be located by the Bluetooth
for 5 sec.
device.
Switch on Bluetooth
2
device.
Search and select "Earebel" and connect the
3
two devices.
As soon as the headphones and the Bluetooth
4
enabled device have been connected, only the
blue LED is lit.
NOTE: To preserve the battery, the headphones switch off auto-
matically if no Bluetooth
connection exists for 5 minutes.
®
17
®
-enabled device, press the
®
blue
and red. The headphones
-enabled
®
on the Bluetooth
-enabled
®
®
EN
-
®
Publicité
Chapitres
Table des Matières
