Publicité
Les langues disponibles
Les langues disponibles
I
N STALLATION
Installation
Television Location
This unit can be used as part of an entertainment center.
your dealer for available options.
•
Avoid excessive sunlight or bright lights, including
reflections.
•
Keep away from excessive heat or moisture. Inadequate
ventilation may cause internal component failure.
•
Fluorescent
lighting
transmitting range.
•
Keep away from magnetic equipment, including motors,
fans and external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between
components. For best results:
•
Use 75-ohm coaxial shielded cables.
•
Use appropriate input and output connectors, that match
your component connectors.
•
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION:
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT
USE A PLUG WITH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT
FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception, either a cable or antenna connection
is required.
Cable Connection
Connect the cable supplied by your local
cablecompany to ANT1 connection on
back of television. Select ANT1 and Cable
mode in SET UP menu.
Note:
A cable converter box may be
required
for
proper
Check
with
your
company for compatibility requirements.
Antenna Connection
For proper reception of VHF/UHF channels, an external antenna
is required. For best reception an outdoor antenna is
recommended.
•
Connect home antenna to ANT1
connection on back of television.
Select ANT1 and TV mode in the
SET UP menu.
Note:
Cable Mode is preset at the
factory.
Antenna
change to TV Mode and ANT 1 in
the Set Upmenu.
4 l
Consult
may
reduce
remote
Polarized plug
Incoming Cable from
Cable Company
75 Ohm VHF/UHF
on back of TV
reception.
local
cable
Incoming Cable from
Home Antenna
users
must
Auto Set Up Menu
For your convenience, Auto Set up menu will be displayed
on screen when the set is turned on for the first time. If
needed, follow the menus and procedures for setting up the
features.
IDIOMA/LANGUE
To change menu language to ENGLISH, SPANISH or
control
FRENCH.
Procedure
Press VOL u to select English, Spanish or French.
•
MODE
To select TV (antenna) or CABLE mode depending on the
signal source.
Procedure
Press VOL u to select TV or CABLE.
•
AUTO PROGRAM
To automatically program all channels with a signal.
Procedure
Press VOL u to start Auto Programming.
•
CONVERGENCE
To adjust the center convergence, if needed.
Procedure
Press VOL u to display center Convergence adjustment
•
menu.
•
Refer to page 27 for setting Convergence, if needed.
Publicité
