Publicité
FOR CUSTOMER SERVICE CALL: 800-750-2723 EXT 5050
TOOLS AND MATERIALS
You will need a drill with a 1/8" bit to install sheet metal
screws into connector pipe. A 5/16" socket/wrench
or screw driver to install the room air deflector, and
blower assembly described. A 1/2" socket/wrench to
install flue collar. A non-combustible floor protector
as specified in this manual. All chimney and
chimney connector components required for your
particular chimney installation. For mobile homes
see the "For Use In Mobile Homes" section of this
manual.
BLOWER ASSEMBLY
The blower assembly must be disconnected from
the source of electrical supply before attempting
the installation. The blower assembly is intended
for use only with a stove that is marked to indicate
such use. Do not route the supply cord near or
across hot surfaces! Fix the assembly to the back of
the stove with the four screws provided.
© 2021 United States Stove Company
ASSEMBLY INSTRUCTIONS
ASH PAN ASSEMBLY
Remove ash pan from firebox. Under the firebox,
there are two brackets; Slide the ash pan into these
brackets.
FLUE COLLAR ASSEMBLY
Mount the flue collar to the top of the unit as shown
using the (3) 5/16-18 x 1-1/2 bolts, (3) washers, and (3)
weld tabs provided in the parts box.
4
5/6-8 x 1-1/2 BOLT
WASHER
GASKET
HEATER TOP
WELD TAB
Publicité
