Sauder OFFICE WORKS 427442 Instructions De Montage page 6

Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Insert four WOOD DOWELS (42F) into the exact holes
shown in the MODESTY PANEL (D).
å
NOTE: You may need to gently tap the WOOD DOWELS
in with your hammer.
42F
Page 6
FASTENER
®
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
427442
2.
1. Insert the dowel end of the FASTENER
into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER
must remain fully inserted in the hole of the
adjoining part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
D
www.sauder.com/commercial-office/service
Dowel end
0
42F