Home Decorators Collection HM0906-1 Guide D'utilisation Et D'entretien page 5

Installation
1
ATTACHING THE MOUNTING UNIT TO
THE JUNCTION BOX
□
Remove the two pre-assembled screws and washers from the
mounting bracket (AA).
□
Screw the mounting screws (BB) through the holes on the
mounting bracket (AA) into the screw holes on the outlet box.
2
MAKING THE ELECTRICAL CONNECTIONS
□
Connect the copper wire from the fixture body (A) to the mounting
bracket (AA) by securing it with the pre-installed ground screw.
□
Connect the black wire from the fixture to the black wire from
the outlet box, the white wire from the fixture to the white
wire from the outlet box, and the copper wire from the fixture to
the ground wire from the outlet box with the wire nuts (CC).
Secure with electrical tape (not included).
NOTE: If the wires from the fixture are the same color,
attach the side with markings or letters to the black
(positive) wire and the other to the white (neutral) wire.
3
SECURING THE LIGHT FIXTURE
□
After wires are connected, tuck them carefully inside the
junction box.
□
Put the fixture body (A) over the mounting bracket (AA).
□
Secure the light fixture with two previously-removed screws
and washers.
CAUTION:
To avoid any waterpro
make sure the lig
perfectly during installation and use waterproof glue around
the canopy for better sealing after installation.
g problems, please
xture s the mounting surface
AA
5
Please contact 1-800-986-3460 for further assistance.
AA
AA
A
HOMEDEPOT.CA
CC
A