Rally Armor IMF69 Instructions D'installation page 2

FRONT MUD FLAP
Hardware & Bracket 1 x Front Flap  1 x BMF63; 2 x 1SS; 1 x 2.5SS; 3 x SMWASH; 1 x 1.5SP
Turn the steering wheel towards the side you are working on to gain access to the inner wheel well area.
FIGURE A Remove fender liner fasteners 1, 2, and 3.
FIGURE B Place mud flap logo-side facing the rear of the vehicle against corresponding mounting points of BMF63 Bracket and fender.
Install 1SS Screws & SMWASH Washers through BMF63 BRACKET in mounting points 1 and 2. For mounting point 3, place 1.5SP Plastic
spacer behind the mud flap. Fasten with 2.5SS Screw & SMWASH Washer tightening only until seated. Do not overtighten.
FIGURE C View the rear of the vehicle to ensure the flaps are aligned. Make slight adjustments before tightening all mounting screws.
REAR MUD FLAP
Hardware & Bracket for 1 x Rear Flap  1 x BMF57-LR/RR; 1 x SSLNUT; 1 x 1MCHSS; 3 x 1SS; 1 X IN5; 4 x SMWASH
FIGURES D/E Remove all wheel liner screw fasteners 1,2, and 3. Remove lower liner retainer.
FIGURE F Install BMF57-LR/RR Rear bracket using INS5 insert.
FIGURE G
Ensure BMF57-RR/LR stud is facing forward.
FIGURE H
Install 1SS Screw using SMWASH Washer into mud flap through points 1, 2 ,and 3. Secure mounting point 4 with SSLNUT
Lock nut and SMWASH Washer. Tighten only until mud flap is level with bumper. Do not overtighten.
FIGURE I
Align outer edge of the flap by adjusting until the flap is perpendicular to even ground. Hand tighten until washers are seated.
2021+ Hyundai Elantra Mud Flap Installation Instructions
IMF69
2
Version 1.0 Release Date Nov-17- 2020