LUTEC 6940004012 Manuel D'utilisation page 7

5
A
Attach the Lampshade (A) to the Elbow Components (B) by rotating the lampshade (A) clockwise.
Then install the Bulbs (A3) and the Diffusers (A1) by rotating clockwise.
7
A
Turn ON the On/Off switch located on the underneath area of the Lampshade (A). Loosen
preassembled Set Screw (B1) counterclockwise from Lamp Head base. Do not remove set screw.
Carefully screw the lamp head onto Top Pole (C) by rotating clockwise. Secure by tightening the Set
Screw (B1) clockwise until tight with a flathead screwdriver (not included).
Warning:
LED lights will not automatically turn on unless the battery has been charged and it is
dark outside. You can test the lights by placing the empty box upside down over the Post Light Head.
Once dark, the LED lights should turn on in several seconds.
B
OFF ON
OFF ON
6
8
7
A3
A1
B1
C