sunjoe SWD12000 Mode D'emploi page 11

Fig. 12
4. Use a mild soap and water solution to wash the foam filter
and rinse with clean water. Allow the wet filter to air dry for
24 hours before installing onto the filter cage.
5. To assemble the filter, fit the foam filter on the filter cage
(Fig. 13).
Fig. 13
Foam filter
Storage
1. Examine the electric wet/dry vacuum thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Examine the appliance cord thoroughly for signs of
excess wear or damage. If it is worn or damaged,
replace it immediately.
3. Store the wet/dry vacuum indoors in a clean, dry and
locked location out of the reach of children and animals.
4. When not in use, the equipped tubes, handles and nozzles
can be temporarily stored in the onboard accessories
storage and onboard accessories storage (Fig. 14).
Foam filter
Service and Support
If your Sun Joe
service or maintenance, please call the Snow Joe
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Model and Serial Numbers
When contacting the company, reordering parts or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
+
located on the housing of the unit. Copy these numbers into
®
+ Sun Joe
® ® the space provided below.
11
Fig. 14
Onboard
accessories
storage
SWD12000 electric wet/dry vacuum requires
®
Record the following numbers from the housing or handle of your
new product:
Model #:
S W D 1 2 0 0 0
Serial #:
Onboard vacuum hose +
power cord storage
+ Sun Joe
® ®