Publicité
Déclaration de performances
1
Déclaration de performances
6
EC-declaration of conformity
This EC declaration of conformity applies to the product described below and describes the conformity with the following
directives:
2009/125/EC Directive for the setting of eco-design requirements for energy-related products (eco-design directive)
Relevant Regulation: (EU) 2015/1185
Declaration of Performance
According to regulation (EU) 305/2011
No. 1.241-081-1 - CPR-2013/07/01
1.
Unique identification code of the product-type
2.
Intended use or uses of the construction product, in
accordance with the applicable harmonised technical
specification, as foreseen by the manufacturer
3.
Name, registered trade name or registered trade mark
and contact address of the manufacturer as required
pursuant to Article 11(5)
4.
Where applicable, name and contact address of the
authorised representative whose mandate covers the
tasks specified in Article 12(2)
5.
System or systems of assessment and verification of
constancy of performance of the construction product
as set out in Annex V
6.
In case of the declaration of performance concerning a
construction product covered by a harmonised
standard
7.
Declared performance
Harmonized technical specification
Essential characteristics
Fire safety
Distance to combustible materials
Risk of burning fuel falling out
Emission of combustion products
Surface temperature
Electrical safety
Cleanability
Release of dangerous substances
Maximum operating pressure
Flue gas temperature at nominal heat output
Mechanical resistance (to carry a chimney/flue)
Thermal output
Nominal heat output
Room heating output
Water heating output
Energy efficiency
8.
The performance of the product identified in point 1 is in conformity with the declared performance in point 7.
This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 3.
Signed for and on behalf of the manufacturer by:
Danny Baijens, CEO
(Name and function)
Bladel; October 2, 2023
(place and date of issue)
Evo-7 Compact 55-45
Room heater without hot water supply
Barbas Bellfires BV; Hallenstraat 17; 5531 AB Bladel; The Netherlands
Not applicable
System 3
The notified laboratory SGS Belgium NV, No. 1639 performed the
determination of the product type on the basis of type testing under system 3
and issued test report EZKA/2023-09/00005-1
EN13229:2001/A2:2004/AC:2007
Performance
Pass
Minimum distances, in mm
Insulation thickness rear =
100
Insulation thickness sides =
100
Insulation thickness ceiling =
75
Front =
1800
Insulation thickness floor =
30
Pass
CO = 0.1 vol%
Pass
Pass
Pass
NPD
Not applicable
T = 325 °C
NPD
Pass
10.7 kW
10.7 kW
- kW
75.4 %
...................................................................................
(Signature)
EVO-7 Compact 55-45
Publicité
