Honeywell TP30 Mode D'emploi page 20

TROUBLESHOOTING GUIDE (CONTINUED)
PROBLEM POSSIBLE CAUSE
Unit runs but
Insufficient time for the
the humidity
dehumidifier to remove
level does
moisture.
not decrease
Area to be dehumidified
is too large.
Dehumidifier
runs constantly/
does not stop
A door or window is open,
letting in new moisture.
The water tank is full.
Water Tank
Full is
illuminated
and the unit is
beeping
The water tank is not in
the correct position.
The unit is
The purpose of the top
blowing cold air
air vent is to distribute air
out of the top
into the room.
vent
Dehumidifier has been
recently turned on in low
Frost appears
room temperatures
on the coils
(usually below 41°F
(5°C)).
Connected
the continuous Some floors may have
drain but an uneven surface
the water which may affect the
condensation is continuous drainage
not draining out function
the tube
SOLUTION
After initial installation, allow 24 hours to maintain
desired dryness.
The capacity of your dehumidifier may not be
adequate for the room it is used in. It is recommended
to add an extra dehumidifier for large areas.
Make sure all windows or doors to the
outside are closed and tightly sealed.
Empty the water tank.
Position the water tank correctly into the unit. Unit
will not operate until the water tank is secure in place.
The temperature of the air from the vent depends
on the room environment and other factors. It can
fluctuate and this is normal. No action required.
This is normal. Frost will disappear in an hour
or so after the dehumidifier is switched OFF.
Raise the front of the Dehumidifier ½ to 1 inch
(1.27 cm to 2.54 cm) from the floor. The water
condensation will drain out the back hose and not
into the bucket.
EN 19