Sauder 425212 Mode D'emploi page 5

Step 3
å
Turn your unit onto the LEFT END (B).
å
Fasten the RIGHT END (C) to the BACK BRACE (E). Tighten a LARGE 1-9/16" HEX HEAD SCREW (1) using
the L-WRENCH (3).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Fasten the RIGHT END (C) to the BOTTOM BRACES (D). Tighten two LARGE 1-9/16" HEX HEAD SCREWS (1)
using the L-WRENCH (3).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
LARGE 1-9/16" HEX HEAD SCREW
(3 used in this step)
425212
1
3
C
D
B
www.sauder.com/service
E
D
Page 5