aero pure AP200D-S Mode D'emploi page 2

CLEANING & MAINTENANCE
For quiet and efficient operation, long life, and attractive appearance - lower or remove grille and vacuum interior of unit
with the dusting brush attachment.The motor is permanently lubricated and never needs oiling. If the motor bearings are
making excessive or unusual noises, replace the motor with the exact service motor. The impeller should also be replaced.
OPERATION
Use an on/off switch to operate this fan. See "CONNECT ELECTRICAL WIRING" for details.
PLAN THE INSTALLATION
1. Do not use in a cooking area.
2. Two ways to connect ductwork to a factory-shipped unit.
ASSEMBLY INSTRUCTIONS
1. Sliding hanger bars have been provided, which allow the housing
to be positioned accurately anywhere between the framing. The
bars span up to 24 in. and can be used on all types of framing:
I-joist, standard joist, and truss construction. Slide hanger bars onto
housing and adjust as needed to fit between framing.
2. Extend the hanger bars to the width of the framing. Position the
ventilator with the bottom edge of the hanger bar tabs are flush with
the bottom edge of the framing, holding the ventilator in place.
Secure hanger bars to framing using one screw on each end of
hanger bar. Select a proper hole and secure the hanger bars
together using one screw.
INSULATION*
(Place around and
over Fan Housing.)
FAN
POWER
HOUSING
CABLE*
Seal gaps
around
Housing.
ROUND
DUCT*
Seal duct
*
Purchase
joints with
separately tape.
Hanger Bar
2
ROOF CAP*
(with built-in
damper)
Keep duct
runs short
WALL CAP*
(with built-in
ROUND
damper)
ELBOW(S) *
screw