Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS
WARNING:
When using this product basic precautions should always be followed, including but not limited to
the following:
1. Observe the use and safety instructions of your pressure washer.
2. The Surface Cleaner must not be used by children.
3. Only trigger the gun of the pressure washer if the Surface Cleaner is on the surface to be cleaned.
4. Keep all persons/animals clear of the immediate vicinity of the cleaning head.
5. Keep hands away from moving parts.
6. Turn off the pressure washer and relieve the pressure when examining or changing the Surface
Cleaner and after the completion of the cleaning operation.
7. Maximum water temperature allowed is 140 °F/ 60 °C.
CAUTION:
1. The Surface Cleaner is not suited for scouring or scrubbing.
2. Do not run over freestanding corners.
3. Test the Surface Cleaner on a small, hidden area before proceeding to a larger surface.
4. Not to be used on vertical surfaces.
INTENDED USE
1. The Surface Cleaner can be used with electric and gas pressure washers up to 3400 PSI.
2. Use on horizontal surfaces like driveways, patios, sidewalks, etc.
ASSEMBLY
1. The surface cleaner comes completely assembled and
ready for use.
2. Attach the surface cleaner's 1/4 in. quick connect plug
into the end of the pressure washer wand (See Figure 1).
3. Connect hose to the pressure washer and start
pressure washer as described in its Owner's Manual.
CAUTION:
1. Risk of injury can occur if the surface cleaner 1/4 in.
quick connect plug is not properly inserted into the quick
connect coupler. Make sure you hear a "click" sound
when attaching the 1/4 in. quick connect plug to the
quick connect coupler.
2. Pull the Surface Cleaner to make sure it is seated
properly before operating your unit.
OPERATION
1. Squeeze the trigger and move the surface cleaner
back and forth and/or side to side to begin cleaning.
2. Never operate in the same area for more than
2 seconds as damage may occur.
NOTE: If striping or swirling occurs:
1. Slow your pace and try cleaning the area by going
back and forth and side to side.
2. Try overlapping by 50% (when cleaning).
NOTE: Always squeeze the gun's trigger to release any
residual pressure immediately after use. Engage the
trigger lock when not in use.
Figure 1
Figure 2
3
Quick Connect
Coupler
1/4 in. Quick
Connect Plug
www.surfacemaxx.com
Publicité
