Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
Models: BFC90, BFC90H
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN
THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock and
WARNING:
OF FIRE, ELECTRIC SHOCK AND INJURY TO
PERSON, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service
panel and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
WARNING:
OF FIRE, ELECTRIC SHOCK AND INJURY TO
PERSON, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
b) Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment manufacturer's guideline
and safety standards such as those published by the National Fire
Protection Association (NFPA) and the American Society for Heating,
Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local
code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
6727922 BFC90 Rev. F 8-19
OPERATING MANUAL
INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
injury to person, including the following:
TO REDUCE THE RISK
TO REDUCE THE RISK
SAVE THESE INSTRUCTIONS
CAUTION:
DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE
MATERIALS AND VAPORS.
d) Ducted fans must always be vented to the outdoors.
e) This unit must be grounded.
f) To avoid motor bearing damage and noisy and/or unbalanced impellers,
keep drywall spray, construction dust, etc. off power unit.
g) Read all instructions before installing or using exhaust fan.
a) If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application and be connected to a
GFCI (Ground Fault Circuit Interrupter) – protected branch circuit.
WARNING:
WARNING:
OUTSIDE OF THE BUILDING HAS A STRONG EFFECT
ON THE AIR FLOW, NOISE AND ENERGY USE OF THE FAN. USE
THE SHORTEST, STRAIGHTEST DUCT ROUTING POSSIBLE FOR
BEST PERFORMANCE, AND AVOID INSTALLING THE FAN WITH
SMALLER DUCTS THAN RECOMMENDED. INSULATION AROUND
THE DUCTS CAN REDUCE ENERGY LOSS AND INHIBIT MOLD
GROWTH. FANS INSTALLED WITH EXISTING DUCTS MAY NOT
ACHIEVE THEIR RATED AIRFLOW.
www.airkinglimited.com
Exhaust Fan
FOR GENERAL VENTILATING USE ONLY.
WARNING:
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, DO NOT USE THIS FAN WITH
ANY SOLID-STATE SPEED CONTROL DEVICE.
DO NOT USE IN KITCHENS.
THE DUCTING FROM THIS FAN TO THE
1 of 8

Publicité

loading

Sommaire des Matières pour AirKing BFC90

  • Page 1 When cutting or drilling into wall or ceiling, do not damage electrical THE DUCTS CAN REDUCE ENERGY LOSS AND INHIBIT MOLD wiring and other hidden utilities. GROWTH. FANS INSTALLED WITH EXISTING DUCTS MAY NOT ACHIEVE THEIR RATED AIRFLOW. SAVE THESE INSTRUCTIONS 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 1 of 8...
  • Page 2 Figure 2 Cover SECTION 4 Ducting NOTE: 4" OR LARGER RIGID DUCT IS RECOMMENDED FOR BEST PERFORMANCE. Screw CAUTION: Figure 5 ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL BUILDING CODES. 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 2 of 8...
  • Page 3 Plug the fan’s quick connect motor cord into the receptacle. This cord will only fit one way into the receptacle (Figure 8). Figure 8 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 3 of 8...
  • Page 4 5S2251003 Wire Compartment w/Humidistat (BFC90H) 5S2251008 Blower Assembly 5S2251004 Grill Springs 5S2251005 Grill 5S2251006 Knob 5S1299802 Wire Cover 5S2251002 Plastic Damper Plate 5S2251009 Installer: Installation Date: Place of Purchase: Model Number: 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 4 of 8...
  • Page 5 AUTOUR DES CONDUITS PEUT RÉDUIRE LA PERTE D’ÉNERGIE ET EMPÊCHER LE DÉVELOPPEMENT DE MOISISSURES. IL SE PEUT QUE LES VENTILATEURS INSTALLÉS AVEC DES CONDUITS EXISTANTS N’ATTEIGNENT PAS LEUR DÉBIT D’AIR NOMINAL. CONSERVER CES INSTRUCTIONS 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 5 of 8...
  • Page 6 REMARQUE : La canalisation de ce ventilateur à l’extérieur du bâtiment a un effet important sur le flux d’air, le bruit et la consommation d’énergie du ventilateur. Utilisez la route de canalisation 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 6 of 8...
  • Page 7 Brancher le cordon à raccordement rapide dans le réceptacle. Ce cordon ne s’ajuste que d’une seule façon dans le réceptacle (Figure 8). Figure 8 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 7 of 8...
  • Page 8 Ressorts de la grille 5S2251005 Grille 5S2251006 Bouton 5S1299802 Couvercle de Câble 5S2251002 Plaque d’amortisseur en plastique 5S2251009 Installateur : Date d’installation : Endroit de l’achat : Numéro de modèle : 6727922 BFC90 Rev. F 8-19 www.airkinglimited.com 8 of 8...

Ce manuel est également adapté pour:

Bfc90h