Lacme L.BOX LD Installation Rapide page 2

1
CREATE AN ACCOUNT
ON THE LBOXLD APPLICATION
Scan the QR code above
Or go to your Playstore.
Download the LBOXLD application.
Open the application.
2
INSTALL L.BOX LD
AND ASSOCIATE IT WITH YOUR ACCOUNT
Connect L.Box LD to the sector.
Fixed yellow LED = L.Box LD under tension
Using the RJ45 network cable supplied,
connect it to your Internet box.
LED flashes blue = current connection
Fixed blue LED = L.Box LD is connected to
the Internet
3
INSTALL A CONNECT'LD ENERGIZER
AND ASSOCIATE IT WITH YOUR ACCOUNT
To add to your account, Click on one of the options
the Connect'LD energizer, proposed and follow the
+
push the button instructions.
QUICK SETUP
To add L.Box LD,
click on one of the options
proposed and follow the
instructions.
To launch the operation,
disconnect and reconnect
your energizer Connect'ld on
mains.
Fill in the fields.
For your your password to be valid, it
must contain at least:
• 8 characters including :
• 1 tiny
• 1 capital
• 1 figure
• 1 special character
Check the box "Remember me"
for a quick connection without filling in at
the future your identifier and password
Select
Create my account
Note: an email containing a confirmation
link is then automatically sent to you. You
can treat it later.
To launch the operation,
disconnect then reconnect
L.Box LD
HAVE YOU JUST ACQUIRED A CONNECT'LD ENERGIZER?
For practical reasons, we suggest that you connect it
near the L.Box LD box during the association phase below.
Once successful, you can install it at the desired location.
IS YOUR CONNECT'LD ENERGIZER ALREADY IN OPERATION?
Follow the recommendations below.
LED flashes blue = connection in progress with L.Box LD
Fixed blue LED = the energizer is connected to L.Box LD
The gateway is well
linked with your account !
Your energizer Connect'ld
is well linked with your
account !