NUTRIBULLET NB14350K Mode D'emploi page 11

Errors.
Too many blends
Light ring will flash red, alternating
between top and bottom LEDs.
Solution:
to cool before next use. Don't exceed 9
blending cycles within 6 minutes.
Overheat
Light ring will turn red.
Solution:
blender to cool before next use.
General error
Light ring will flash red.
Troubleshooting:
Make sure your Cup is secured and
aligned properly.
If the blade is blocked, then try the following:
•
Add more liquid to the Cup and try
blending again.
•
Shake blender or turn upside down to
remove blockage.
•
Turn unit off and remove blockage from
blade using a utensil.
20
Pause activity and allow blender
Pause activity and allow
WARNING!
Before first use, review
all warnings and caution
statements in the important
safeguards section
(pages 2-13).
ALWAYS make sure
your blender is clean and
charged before use.
Fully charge your blender
before first use. The charging
port is located under the light
indicator of the Motor Base.
(See the assembly section on
page 17 for reference.)
DON'T run your nutribullet
®
Portable Blender when empty.
DON'T microwave any
nutribullet accessories.
®
DON'T leave your nutribullet
®
Portable Blender unattended
when in use.
DON'T charge your nutribullet
®
Portable Blender if your USB-C
Cable is wet.
DON'T use hot or warm
ingredients in your blending
cup. Heated ingredients can
cause pressure to build up in
the sealed cup that may expel
hot contents upon opening,
potentially causing personal
injury or property damage.
NEVER run the nutribullet
®
Portable Blender for more than
one minute at a time, as it can
cause permanent damage to
the motor. If the motor stops
working, pause activity and
allow the blender to cool. Your
nutribullet Portable Blender
®
has an internal thermal breaker
that shuts the unit off when it
overheats. Letting the thermal
breaker cool down should allow
it to reset.
ALWAYS inspect your blade.
During the warranty period,
contact Customer Service
before removing the blade
for safety instructions
and replacement.
21