RF Solutions Keeloq FOBLOQA-4T1 Mode D'emploi page 9

Keeloq TM Key Fob
FCC Compliance (433MHz products)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference,
including interference that may cause undesired operation. Changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate the
equipment.
European compliance information (433 and 868MHZ Products)
This RF Solutions product meets the essential requirements of the European Radio Equipment Directive
2014/53/EU and has been tested to European Harmonised Standards and CE marked accordingly. A copy
of the EU Declaration of Conformity can be located on the RF Solutions Website,
www.rfsolutions.co.uk/certification-i59.
FCC Compliance (918MHz products)
At the time of writing we are currently in the certification stage for both USA and Australia
Replacing the battery
Remove the screws holding the back panel in place. Open the case and change the battery. Ensure you
check the orientation of the battery.
Battery Type CR2032 (supplied)
DS-FOBLOQ-2