Disposal Of The Packaging; Requirements On The Setup Location - SilverCrest KH 2431 Mode D'emploi

Setting up and connecting

Disposal of the packaging

The packaging protects the device from transport damages. The packaging materi-
als are selected from the point of view of their environmental friendliness and
disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces the amount of waste generated. Dispose of packaging material that is
no longer needed as per the regionally established regulations.
NOTE
► If possible, preserve the device's original packaging during the warranty
period so that, in the event of a warranty claim, you can package the
device ideally for its return.

Requirements on the setup location

For safe and trouble free operation of the device the setup location must fulfi ll the
following provisions:
■ The device must be placed on a fi rm, fl at and level surface.
■ Do not place the device in a hot, wet or very damp environment or in the
vicinity of fl ammable materials.
■ Do not remove the device's pads. If you do, air circulation in the device will
be impaired.
■ The mains power socket must be easily accessible so that the power cable
can be easily disconnected in an emergency.
■ The surface areas of furniture may possibly contain components that could
aff ect the device's rubber pads, softening them. If necessary place a cover
under the device's pads.
■ Operating temperature range: +5 to +40 °C
■ Humidity (no condensation): 5 - 90 %
KH 2431
GB
99