Publicité
Les langues disponibles
Les langues disponibles
Fireplace Installation
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
Construction and electrical outlet
wiring must comply with local
building codes and other applica-
ble regulations to reduce the risk
of fire, electric shock and injury to
persons. Do not attempt to wire
your own new outlets or circuits.
To reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
All manuals and user guides at all-guides.com
Figure 1
Front Glass Installation
1. Unpack the glass assembly.
2. If applicable, carefully pour
3. Hang bottom bracket on
4. Secure the top bracket to fire-
Figure 2
and evenly distribute the sup-
plied media in the Media tray
of the firebox (Figure 2).
screw at the bottom of the
firebox. (Figure 1)
box using screws provided in
the hardware bag. (Figure 1)
Media
Tray
7
Publicité
