Publicité
Les langues disponibles
Les langues disponibles
Step 4. Dishwasher installation steps
Please refer to the specified installation steps
in the installation drawings.
1. Affix the condensation strip under the work surface of cabinet.
Please ensure the condensation strip is flush with edge of work
surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. The rear foot can be adjusted from the front
of the dishwasher by turning the Philips screw in the middle of the
base of dishwasher use an Philips screw. To adjust the front feet, use
a flat screw driver and turn the front feet until the dishwasher is
level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step 7
to Step 10)
8. Adjust the tension of the door springs by using an Allen key turning
in a clockwise motion to tighten the left and right door springs.
Failure to do this could cause damage to your dishwasher. (Step 11)
9. The dishwasher must be secured in place. There are two ways to do
this:
A. Normal work surface: Put the installation hook into the slot of the
side plane and secure it to the work surface with the wood screws.
B. Marble or granite work top: Fix the side with Screw.
A
B
23
V.1
Publicité
