Panasonic S-15MY3E Mode D'emploi page 5

The appliance shall be stored
in a room without continuously
operating open flames (for
example: an operating gas
appliance) and ignition sources
(for example: an operating electric
heater).
Stop using the product when any
abnormality/failure occurs and
disconnect the power plug or turn
off the power switch and breaker.
(Risk of smoke/fire/electric shock)
Examples of abnormality/failure:
• The ELCB trips frequently.
• The product sometimes does not
start when turned on.
• The power is sometimes
disconnected when the cord is
moved.
• Burnt odor or abnormal noise is
detected during operation.
• The body is deformed or
abnormally hot.
• Water leaks from the indoor unit.
• Power cord or plug becomes
abnormally hot.
• Fan speed cannot be controlled.
• The unit stops running
immediately even if it is switched
on for operation.
Contact immediately your local
dealer for maintenance/repair.
When the optional "R32 refrigerant
leakage detection sensor" detects
refrigerant leakage, P08 alarm and
inspection mark will be displayed
on the remote controller, the
indoor unit fan will be running to
prevent refrigerant stagnation, and
it will not stop even if you press
the ON/OFF operation button on
remote controller. In such a case,
do not turn off the ELCB, ventilate
the room, and contact the service
dealer immediately. Also, do not
use combustion equipment such
as stoves.
WARNING
Do not sit or step on the unit.
You may fall down accidentally.
If refrigerant R32 is used and
R32 refrigerant leakage detection
sensor is connected to the indoor
unit, do not turn off the ELCB of
the indoor unit except when there
is a symptom of abnormality or
failure, or when performing short-
term maintenance. (When the
ELCB is turned off, R32 refrigerant
leakage detection sensor cannot
detect the refrigerant leakage
when the refrigerant leaks, and it
may lead to cause the generation
of toxic gases and fires.)
Do not use the following items
near the indoor unit and R32
refrigerant leakage detection
sensor as they may cause fire
or false detection of refrigerant
leakage.
• Gas equipment that uses
flammable gas (propane,
methane, etc.)
• Combustible gas such as
pesticides and hair spray (LPG,
etc.)
• Sprays, drugs, chemicals,
paints, etc. that use siloxane.
5