HIKOKI CV 12DA Mode D'emploi page 9

NAMES OF PARTS (Fig. 1 – Fig. 13)
Switch
LED light
Attachment ring
M6 bolt
Nameplate
Handle
Dial
Battery
Latch
Hexagonal bar wrench
Wrench holder
Pilot lamp
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
CV12DA: Cordless Multi Tool
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V
Rated voltage
n
No-load speed
0
min -1 Oscillation per minute
Oscillation angle, Total (left / right)
Weight*
kg (According to EPTA-Procedure 01/2014)
Switching ON
Switching OFF
Disconnect the battery
Pad
Display panel
Remaining battery
indicator switch
Remaining battery
indicator lamp
Retaining hole
Attachment ring lug
Blade
Sanding plate
Sanding paper
Dust collection adapter
Felt packing
Hose
9
Sanding paper
Blade
Cutsaw
Accessory case
Warning
Prohibited action
* Depending on attached battery. The heaviest weight is
measured with BSL1240M (sold separately).
Battery
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 3 seconds.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 171.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Flush cutting and pocket cutting of various materials
○ Peeling of tiles, caulking, etc.
○ Polishing wood materials, etc.
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 171.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
English