Power Dynamics PD615SA Manuel D'instructions page 3

REAR PANEL
1. High Pass XLR Output
These outputs are used to send the incoming signal
to a full range active speaker or power amplifier.
2. XLR Output
Are used to send the signal from FULL RANGE
INPUTS to another device.
3. XLR/Jack 6.3mm Input
Are designed to accept a line input signal from a
mixer or other line devices with a balanced jack. Use
balanced cables in order to prevent signal loss.
ONLY USE LINE LEVEL INPUT DEVICES.
4. Crossover Control
To regulate the crossover frequency between 50-
150Hz.
5. Subwoofer Level Control
To regulate the output level of the subwoofer. Use this for setting the balance between the subwoofer and the main
speakers.
6. Phase Switch
This switch reverses the polarity of the subwoofer. Experiment (placement of the subwoofer relative to the speakers)
with all speakers to find the best sound.
7. Signal LED
When lit, the signal presence at the audio input.
8. Power LED
When lit, the power is on.
9. Power Switch
Push to turn ON / off the amplifier. Before switching
the amplifier on, check all connections and turn fully
counter clockwise the volume control (5).
10. Fuse
220-240V~ T3.15 AL 250V
11. Power cord input
Before connecting the power cord, check if the mains
corresponds to the voltage indicated on the rating plate on the unit. Connect the power cord only to a mains socket
outlet with a protective earthing connection.
3