LENCO LPJ-280WH Mode D'emploi page 13

Install/Remove Battery Of Remote
Remove the battery compartment cover on the back of your remote by carefully
sliding it open. The battery cover can then be lifted away. Fit the correct batteries
(2 X AAA batteries not included), referring to the polarity markings. Finally,
replace the cover.
NOTES:
•
Batteries shall not be exposed to excessive heat such as direct sunlight,
fire.
•
Be sure to check the correct polarity when installing the batteries
•
Do not mix old and new batteries.
•
Only use type AAA/LR03/UM4 type batteries
•
Do not throw batteries into fire because it may explode. Never try to
recharge a single use battery.
•
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,
etc.) batteries.
12