Uline H-11161 Installation page 2

ATTACHING POST TO BASEPLATE
1. Position baseplate in the approximate location
required. Insert post into baseplate.
2. Using provided Allen wrench, tighten pre-installed
screws on baseplate. (See Figure 5)
Figure 5
MOUNTING BASEPLATES
1. Verify that all posts are positioned in the desired
location. Mark the floor where holes will be drilled.
WARNING! Wear eye protection when
completing step 2.
2. Using a 7/16" drill bit, drill a hole 2⁄" deep into
the floor.
NOTE: For the anchor to function properly, the
hole must not be larger in diameter than the
anchor bolt.
3. Clean out debris and dust from inside the hole. Fully
insert the anchor bolt through the baseplate and
into the hole. (See Figure 6)
Figure 6
Anchor Bolt
PAGE 2 OF 6
INSTALLATION CONTINUED
Screw
4. Slightly tap down the anchor bolt with a hammer.
5. Repeat steps 1-4 to assemble remaining anchors.
1-800-295-5510
uline.com
NOTE: Thread washers and nut onto anchor
bolt. Nut should be tightened halfway between
end of bolt and top of anchor sleeve.
(See Figure 7)
Figure 7
Tighten Not all the
halfway
Tighten the nut with a wrench until the anchor bolt is
secure. (See Figure 8)
Figure 8
Not all the
way tight way loose
X X
0324 IH-11160