Budda Verbmaster 112 COMBO Mode D'emploi page 22

Rear Panel Functions: What they do and how to use them
REVERB (FOOTSWITCH INPUT):
Plug your two button footswitch in here. The two button footswitch turns on and off the reverb and also
switches between the sand and surf settings. NOTE: The reverb selector knob on the front of the amp
must be set to Sand for the footswitch to work.
EFFECTS LOOP:
This is where you introduce effects into the signal path of your amplifier. To hook up an effect to your
amp, take a 1/4" shielded mono cable and run the send of the amp to the input of the effect and run the
output of the effect into the return on your amp.
SLAVE:
The slave out is an identical replication of the signal coming off the speaker outputs of your amp with a
padded eq circuit. Feel free to experiment by sending the Slave Out signal to an external stereo power
amp feeding a couple of 2x12 or 4x12 extensions for a wall o sound! Another option is to send the Slave
Out signal to a recording console for DI tones to tape, or send it to a board for a signal feed to the mains
for live applications in a club or arena. When slaving make sure that there is always a load on the speaker
out of your amp.
LINE CORd:
For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities.
It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the
Verbmaster™ without proper grounding facilities, use a sutable adapter with the third wire attached to
a known ground. Never remove or break off the ground pin of the plug. Greatly reduced shock hazard
exists when the unit is operated with the proper grounded receptacles.