Fortin PATS KIA 1 Guide D'installation

PATS KIA 1
Copyright © 2006, FORTIN AUTO RADIO INC
TRANSPONDER BYPASS MODULE FOR KIA
WIRING / CONNECTION GUIDE WIRING / CONNECTION GUIDE
START HERE
1
2
3
5
Pats KIA 1
Ignition
6
12V
7
VEHICLE FITGUIDE VEHICLE FITGUIDE
VEHICLES YEARS OF VEHICLE COMPATIBILITY
Kia 2005 2006
Rio
Sedona
Spectra
Spectra 5
Sportage 4Cyl.
TECHNICAL SUPPORT / INFORMATION TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be installed by qualified technician. This instruction guide
V
may change without notice. isit www.ifar.ca to get latest
version.
ALL RIGHTS RESERVED
1
Red
Black
2
Blue
3
1
ANTENNA
Connect wire to vehicle
INSTALLATION AND PROGRAMMING INSTRUCTIONS INSTALLATION AND PROGRAMMING INSTRUCTIONS
Connector 1 (Black):
Make 3 to 4 loops around the ignition barrel.
(Secure the wire with tie-wrap.)
Connector 2 (White):
Connect the red wire to 12V constant.
Connect the black wire to "Ground out when
running".
Hook up the SCAN TOOL
Follow instructions on SCAN TOOL
display for keys programming
procedure (teaching procedure).
Place the PATS KIA 1 transponder
(show on Pats label) close and
toward the front of the ignition barrel
for the next 2 steps.
With the help of a jumper wire,
power up vehicle ignition.
Follow instructions on SCAN TOOL.
2007
12V Battery (+)
(-) While running
N.C
Connect wire to Remote starter/Alarm
8
Pats KIA 1
9
10
11
12
VEHICLES
Hyundai
Entourage
Santa Fe
Technical support:
TEL: 514-255-2720
FAX: 514-255-1367
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada - V3.0.c - November 7, 2006
W e b s i t e : h t t p : / / w w w . i f a r . c a
ALL
IMPORTANT : The PATS KIA 1can only be
programmed once.
Once the PATS KIA 1 is programmed, it can't be
programmed or used on any other vehicle.
Ignition
Remove jumper wire
12V
Remove PATS-KIA 1 module.
ALL
Make sure all other keys still working.
Connect PATS KIA 1 module.
Start vehicle with remote starter.
The module PATS KIA 1 is now
programmed.
YEARS OF VEHICLE COMPATIBILITY
2005 2006 2007
You must have all
keys available.
You will need the KIA
SCAN TOOL and the
vehicle access code.
OUTPUT INPUT